National-instruments Graphical User Interface Ultiboard Manual de usuario descargar pdf (Pagina 91)

Chapter 3 Setting Up a Design

Complete the following steps to edit a part group:

1. Select Tools»Group Editor to display the Edit Groups dialog box.

2. Select the Part Groups tab.

3. Highlight the desired group in the Groups list.

4. Change the part assignments as desired and click Apply.

5. Optionally, highlight the desired group in the Groups list and click the

Properties button to display the Change group settings dialog box.

6. Make the required changes in the Group Settings area and click OK.

Note Refer to the Change Group Settings dialog box and Net Group Settings sections for

more information.

Complete the following steps to delete a group:

1. Select Tools»Group Editor to display the Edit Groups dialog box.

2. Select the Part Groups tab.

3. Highlight the desired group in the Groups list and click Delete.

Working with Bus Groups

Set up a bus group for traces that you wish to route as closely together as

possible.

Complete the following steps to create a bus group:

1. Select Tools»Group Editor to display the Edit Groups dialog box.

2. Click the Bus Groups tab.

3. Click Add. The Add group dialog box appears.

4. Enter the desired name and click OK.

5. The newly created group appears in the Assign Nets list.

6. Highlight the new group to display a list of nets you can add to the

group in the Assign Nets list, as shown in the example below.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 280 281

Sin comentarios

National-instruments Graphical User Interface Ultiboard Manual de usuario Pagina 91