National-instruments Graphical User Interface Ultiboard Manual de usuario descargar pdf (Pagina 248)

Appendix A Menus and Commands

• Align Top—Aligns the top edges of the selected elements.

• Align Bottom—Aligns the bottom edges of the selected elements.

• Align Center Horizontal—Shifts the selected elements horizontally

so their centers are aligned.

• Align Center Vertical—Shifts the selected elements vertically so

their centers are aligned.

• Align to Coordinate—Displays the Enter coordinate dialog box

where you enter new coordinates for the selected element.

• Space Across—Spaces three or more objects beside each other evenly.

• Space Across Plus—Increases horizontal space between two or more

objects.

• Space Across Min—Decreases horizontal space between two or more

objects.

• Space Down—Spaces three or more objects above each other evenly.

• Space Down Plus—Increases vertical space between two or more

objects.

• Space Down Min—Decreases vertical space between two or more

objects.

Edit»Vertex

You can add or remove vertices from all polygons, whether copper or

non-copper:

• Add Vertex—Adds a vertex to a polygon segment.

• Remove Vertex—Removse a vertex from a polygon.

Refer to the Editing a Polygon section of Chapter 4, Working with Parts,

for more information.

Edit»In-Place Part Edit

Use to edit a part that has already been defined and placed on the board.

Refer to the Editing a Placed Part (In-Place Edit) section of Chapter 4,

Working with Parts, for more information.

Edit»Properties

Displays the properties of the selected element. Results will differ,

depending on what is selected. If no element is selected, displays the board

properties. Properties are described throughout this guide.

1 2 ... 243 244 245 246 247 248 249 250 251 252 253 ... 280 281

Sin comentarios

National-instruments Graphical User Interface Ultiboard Manual de usuario Pagina 248