National-instruments Graphical User Interface Ultiboard Manual de usuario descargar pdf (Pagina 106)

Chapter 4 Working with Parts

NI Ultiboard User Manual 4-10 ni.com

Using Ruler Bars and Guides

Use the ruler bars to place guides on the design, or to measure distances.

Elements on the design will snap to the dotted lines representing the guides

on the design.

To toggle the ruler bars off or on, choose View»Ruler bars.

Complete the following steps to place a ruler guide on the workspace:

1. Click in the ruler bar at the measurement where you want the guide

placed, shown in (1) in the figure below. Guides and dotted lines

appear as shown in (2) & (3) below.

To move a guide, click on it in the ruler bar, and drag it to a new location.

Note If a guide crosses elements on the design, moving the guide will also move the

elements.

To remove a guide, right-click on it in the ruler bar, and choose either Clear

(for a single guide) or Clear All (for multiple guides).

To use a guide to measure, click on it in the ruler bar. Measurements from

the edge of the window and other guides appear, and change if you move

the guide.

1Ruler Bar 2 Placed Guides 3 Dotted Lines

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 280 281

Sin comentarios

National-instruments Graphical User Interface Ultiboard Manual de usuario Pagina 106