National Instruments NI UES-3880 Manual de usuario

NI UES-3880 Hardware Installation Guide First Edition, Sept 2007 P/N: 1802003080110

— 9 — LED Indicators The front panel of the NI Switch contains several LED indicators. The function of each LED is described in the table below. LED

— 10 — where it is not needed. Packets that are used in maintaining the operation of the network (such as the occasional multi-cast packet) are forwa

— 11 — Specifications Technology Standards IEEE802.3, 802.3u, 802.3x Forward and Filtering Rate 148810 pps Packet Buffer Memory 256 KB Processin

— 12 — Technical Support and Professional Services Visit the following sections of the National Instruments Web site at ni.com for technical support

— 13 — Worldwide Technical Support and Product Information ni.com National Instruments Corporate Headquarters 11500 North Mopa

— 1 — Overview The NI UES-3880 is a smart Ethernet switch that provides an economical solution for your Ethernet connections. As an added bonus, the

— 2 — Panel Layout V1 V2 INPUTS: 24 VDCPWR2V2+V2-V1-V1+FAULTPWR112345678ON DIPPORT ALARMTop Panel View1234Rear Panel View

— 3 — Mounting Dimensions (unit = mm) Rear View Side View Front View++9.7513.9051010266Panel Mount Kit (unit = mm)135.0013.10 15.1021.00105.00++25.40

— 4 — DIN-rail Mounting The aluminum DIN-rail attachment plate should already be fixed to the back panel of the switch when you take it out of the bo

— 5 — STEP 3: Once the screws are fixed in the wall, insert the four screw heads through the large parts of the keyhole-shaped apertures, and then sl

— 6 — You should also pay attention to the following items: y Use separate paths to route wiring for power and devices. If power wiring and device w

— 7 — Top ViewFront ViewSTEP 1: Insert the negative/positive DC wires into the V-/V+ terminals. STEP 2: To keep the DC wires from pulling loose, use

— 8 — RJ45 (8-pin) to RJ45 (8-pin) Cross-Over Cable Wiring Cross-Over CableRJ45 Plug Pin 1Switch Port(NIC Port)RJ45ConnectorRJ45ConnectorTx+Tx-Rx+Rx-