National-instruments Order Analysis Toolset Manual de usuario descargar pdf (Pagina 14)

Chapter 1 Introduction to the LabVIEW Order Analysis Toolset

Figure 1-3. Acquire Data with PXI 4472 and TIO VI Configuration Tab

Use the Configuration tab of the Acquire Data with PXI 4472 and TIO VI,

shown in Figure 1-3, to configure the DAQ devices. Use one of the

counters on a TIO device to receive TTL-compatible tachometer pulses.

Use the controls in the TIO Board Setting (Digital Tach Signal) section

of the Configuration tab to configure the TIO device. Use an NI PXI-4472

to acquire the data from the sound or vibration sensor. Use the controls in

the DSA Board Setting (S/V Signal) and Input Settings sections of the

Configure tab to configure the NI PXI-4472. After configuring the DAQ

devices, click the Acquisition tab, shown in Figure 1-4.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 62 63

Sin comentarios

National-instruments Order Analysis Toolset Manual de usuario Pagina 14