National Instruments cFP-20xx Manual de usuario

FieldPointTMcFP-20xxQuick Start GuideWhat You Need to Get Set Up• cFP-20xxLabVIEW RT controller• Mounting hardware (DIN rail, panel-mount, or rack-mou

IInnssttaallll SSooffttwwaarree oonn tthhee HHoosstt PPCCA. Install the software packages you plan to use, such as LabVIEW, LabVIEW RT, Lookout,M

11cFP-20xx Quick Start Guide©National Instruments CorporationC. Click the ++sign next to IIAA SSeerrvveerrwwiitthh OOPPCCin the left pane to expandt

G. Enter values on the Network Settings tab of theSystem Configuration dialog box, shown in thefigure at right. If your network does not have agateway

I. Enter an IP address for the Time Server on theServers tab of the System Configuration dialog box,shown in the figure at right.The time server is a

14cFP-20xx Quick Start Guideni.comFFiinnddiinngg aanndd CCoonnffiigguurriinngg DDeevviicceess aanndd CChhaannnneellss After you have configured

C. To configure the hardware settings of a particular I/O module, right-click the device nameand select EEddiitt tthhiiss ddeevviiccee. The Device C

16cFP-20xx Quick Start Guideni.comD. Click CChhaannnneell CCoonnffiigguurraattiioonnto access the Channel Configuration dialog box, shown in thefigur

17cFP-20xx Quick Start Guide©National Instruments Corporation

18cFP-20xx Quick Start Guideni.comSSaavviinngg HHaarrddwwaarree CCoonnffiigguurraattiioonn aass PPoowweerr--UUpp SSttaatteeWhen you are satisfied

ni.comGo to ni.com/support for the most current manuals, examples, and troubleshooting information. Fortelephone support in the United States, create

2cFP-20xx Quick Start Guideni.comMounting the Backplane on a DIN RailA. Fasten the DIN rail clip(s) to the cFP-BP-xusing a number 2 Phillips screwdri

Mounting the Backplane on a PanelA. Fasten the panel-mount plates to the back of thecFP-BP-xusing a number 2 Phillips screwdriver andthe 8-32 × 5/16 i

Mounting the Backplane in a Standard 19-in. RackA. Fasten the rack-mount bracket to the back of the cFP-BP-xusing the captive screws on thebracket.B.

IInnssttaallll tthhee ccFFPP--2200xxxxCCoonnttrroolllleerr oonn tthhee BBaacckkppllaanneeA. Make sure that no power is connected to the controlle

6cFP-20xx Quick Start Guideni.comIInnssttaallll II//OO MMoodduulleess oonn tthhee BBaacckkppllaanneeA. Align the captive screws on the I/O module

IInnssttaallll CCoonnnneeccttoorr BBlloocckkss oonn tthhee BBaacckkppllaanneeIn order to connect I/O modules to input signals or to external load

CCoonnnneecctt tthhee ccFFPP--2200xxxxttoo YYoouurr NNeettwwoorrkkConnect the cFP-20xxcontroller to an Ethernet network using the RJ-45 Ethernet p

C. Use a separate power supply for each module that needs external power.D. Refer to the operating instructions for the power requirements of each I/O