National Instruments AT Manual de usuario descargar pdf (Pagina 38)

Chapter 2 PCI Serial Hardware Installation, Verification, and Configuration

4. Double-click on the port you want to configure and refer to the

following instructions:

• To view the hardware resources assigned to the serial port, click

on the Resources tab.

• To view or change the port settings, click on the Port Settings tab.

For more information about the settings, refer to the next section,

Port Settings Tab.

• To change the RS-485 transceiver mode, or to enable or disable

the FIFOs on the serial hardware, in the Port Settings tab, click

on the Advanced button. For more information about the settings,

refer to the next section, Port Settings Tab.

Note

Transceiver modes apply to RS-485 interfaces only. For more information about

transceiver modes, refer to Chapter 6, Using Your Serial Hardware.

5. To save your changes, click on the OK button. To exit without saving

the changes, click on the Cancel button.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 207 208

Sin comentarios

National Instruments AT Manual de usuario Pagina 38